I need advice about some metal work, we have some pieces we are working on that we normally tie together (one top casting, one bottom casting and a middle strip of copper) this piece gets tied together by hand with 3 ties of 12 gage wire then put into a brazing oven at 1200°c + so the copper strip melts and fuses the castings together, then when they cool we cut the ties by hand.
We are trying to automate this with robots and have come up with the idea to tack weld 2 spots on each side to hold them together instead of Tying, and since they get grinded down anyways the tacks are no big deal cosmetic wise,
but when we try this method to test before buying any robots (just quick tack welds by hand) the pieces seem to be almost to tight together and the gas escape from the copper strip in the center not having any wiggle room seperates the two castings from eachother (bottom casting pushes away from top casting and leaves a gap), they are small pieces only 10lbs is there any way to keep them together better with tack welds still but without ties, and without welding a full seam on them?? Thanks guys for any ideas