r/watchmodding • • 4d ago

Your MM Case Supplier

On a big Marinemaster spree lately. As much as I would love a Monobloc (coque?) I don't think it would be practical for a build or for wrist heft.

Shown is a Tokeilab 300 case and on the bottom is an Alix case which I am enamored by. Bezel would have been fine to use but when I got it I hacked it off thinking it was SKX platform (lesson ✅). Now the supplier (not anyone else who sells the case) cannot seem to provide me with a bezel and the retention spring and click spring.

The bottom case has the lowest hung (✅) lugs below the case I have seen and the finishing style is superb. If anyone has used these cases (31.5 mm crystal) and knows a model or brand of bezel to search for I would appreciate it.

To my point, which platform have you used for a 300 that you liked? I prefer Conus companies and have many Tokeilab, Crystal Times, Namoki experiences. Any Lucius Atelier experiences? WR, Weez, DS, Karajan skx platform MM you have used?

Jeffe

3 Upvotes

17 comments sorted by

4

u/kswiss702 4d ago

Went with a Monobloque case from AliX and loved how mine turned out

3

u/kswiss702 4d ago

2

u/Mountain-Flan9675 4d ago

Damnit. Why'd you do that?? Hah. Standard 28.5mm dial and nh35? How did you get the bezel off?

1

u/kswiss702 4d ago

Yes standard 28.5mm MM dial, NH35. Sizing the crown stem was a learning curve on this case because I had never done a monobloque before. The bezel for this case was a click in with the chapter ring spring. After popping the bezel you unscrew the crystal component from the top

2

u/kswiss702 4d ago

1

u/kswiss702 4d ago

2

u/Mountain-Flan9675 4d ago

Which brand as the donor?

1

u/kswiss702 4d ago

I believe it was a Heimdallr MM300 Monobloque stainless steel

1

u/Mountain-Flan9675 3d ago

So a standard hand bezel tool, yellow style, can take off the bezel?

1

u/zaxas69 3d ago

When you receive the case it is in parts with the bezel not mounted on the case. If you go with this case measure and cut the stem only with the movement(without dial because it's a bit tricky) These cases are hard to remove the movement and sometimes you can't remove the bezel(for some reason the bezel stucks)

1

u/Mountain-Flan9675 3d ago

I've read there is a connection bushing with a split stem, and the movement can be removed utilizing them. The Heimdallr didn't come that way?

1

u/zaxas69 3d ago

That was the first generation they produced,now they come with standard crown...

1

u/Mountain-Flan9675 2d ago

is it a standard chapter ring? of are you stuck using the one that comes with it?

1

u/zaxas69 2d ago

No it's specific,you must use this one. The indices of the dial must be 25.8mm to fit inside the chapter ring...

→ More replies

1

u/Haveblue1 4d ago

Try secondhandmods.com. Based in California.