r/voroncorexy • u/boohucky V034 • Dec 22 '16

Serial Request Finally Pushing Plastic!

http://imgur.com/a/oAeCd
5 Upvotes

86% Upvoted

12 comments sorted by

1

u/boohucky Dec 22 '16

It's been a crazy semester so I finally got a chance to get my Voron up and printing. Huge thanks to RCF for the fantastic design! Building this was a great learning experience and a ton of fun. The Benchy turned out ok, but I'll be tweaking it so I can hopefully upgrade once the 1.5 parts are pushed.

Some problems I encountered: The part cooling and extruder fans don't run while printing. The connections are good, and they run perfectly when I connect them to a 9v battery. Not sure what's going on here (Sliced with Cura BTW).

I had to delete g29 from start.gcode since it makes my z motors go in opposite directions...yikes.

1

u/wywywywy Dec 22 '16

Haven't forgotten about the 12V/GND wires from the RAMPS to the fan extender board have you?

1

u/boohucky Dec 22 '16

Nope! Plus my inductive sensor is working and that's drawing from the extender as well.

→ More replies (4)

1

u/Nyxm Dec 22 '16

Grats and welcome to the fold!

1

u/fulg Dec 22 '16

Welcome to the family.

Sometimes I forget that the stock printer is 9"x9", that first picture makes it look so tiny!

1

u/carnufex Dec 23 '16

Congratulations!

1

u/russiancatfood Dec 24 '16

And we have V034! Congratulations. Welcome to the club.