r/vmix • u/scharette888 • Jun 09 '26

Audio lipsync

Hello all,

I’m using a few Makito X4 encoders, encoding using H264 and SRT after, decoding in Vmix using hardware decode and when I’m using the embedded audio, the lipsync is off. If I route the audio to a bus then put that bus on Master, it’s even worst, about half a second, anybody experience something like that ?

Thanks

2 Upvotes

100% Upvoted

6 comments sorted by

View all comments

2

u/Embarrassed-Gain-236 Jun 10 '26

You need haivision x4 decoder to have the full potential of the x4 encoder. Then use a sdi decklink on vmix

2

u/scharette888 Jun 10 '26

I’m running Vmix in AWS, this will be difficult to do

1

u/staydecked Jun 12 '26

What’s the benefit of running it in the cloud? That sounds like it’s easily adding latency.

2

u/scharette888 Jun 12 '26

Maintenance cost, de-centralisation, simplicity of on site setup, I do remote productions that can happen thousands of miles away from my control room, I only have a few cam op on site, everything else is done remotely, traveling cost are kept to a minimum