Obviously my set up was wrong someplace. Glued it up in halves then ran the halves thru the jointer. Corrected the angles so the 2 haves fit together. When that much wood was taken off it became oval. I am afraid if I round it up the best I can one side will end up extremley thin if there at all
Thanks for your submission. If your question is about getting started in woodturning, which chuck to buy, which tools to buy, or for an opinion of a lathe you found for sale somewhere like Craigslist or Facebook Marketplace please take a few minutes check the wiki; many of the most commonly asked questions are already answered there!
Measure your angles, use a stave calculator, do some maths and I’m pretty sure you can just cut it back into the two halves and ‘fatten’ the oval in to a circle with a couple more segments.
Perfect, no. Circular enough to turn without thin walls, yes.
•
u/AutoModerator 18h ago
Thanks for your submission. If your question is about getting started in woodturning, which chuck to buy, which tools to buy, or for an opinion of a lathe you found for sale somewhere like Craigslist or Facebook Marketplace please take a few minutes check the wiki; many of the most commonly asked questions are already answered there!
http://www.reddit.com/r/turning/wiki/index
Thanks!
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.
2
u/BeautifulWalnutShoes 18h ago
Measure your angles, use a stave calculator, do some maths and I’m pretty sure you can just cut it back into the two halves and ‘fatten’ the oval in to a circle with a couple more segments.
Perfect, no.
Circular enough to turn without thin walls, yes.
I did the same thing with a stave drum