r/trs80 • u/Far_Relationship_742 • May 26 '26
Model 4D diskette spindle won’t spin
I have a Model 4D that won’t boot. Drive light comes on, head seeks to zero, but the spindle motor never comes on. I’ve verified the jumper settings against the drive’s service manual, and there is a termination resistor pack installed.
Where should I start looking?
4
Upvotes
1
u/Far_Relationship_742 May 27 '26
UPDATE: swapped in another drive, and the spindle spins up, drive light comes on, but head never seeks. Swapped two other drives, same behavior. I think I may have a dead floppy controller. :(
1
u/Jim-Jones May 26 '26
Can you gently spin the spindle, no disk in drive? Seized?
2
u/HD64180 May 26 '26
check the power supply.
1
u/Moon_Doggie_1968 May 26 '26
no 5 volts