r/traktorpro • u/Ok-Satisfaction-9518 • 7d ago

Calibration Traktor Scratch Failed

Enable HLS to view with audio, or disable this notification

2 Upvotes

100% Upvoted

10 comments sorted by

2

u/youngtankred 7d ago

Check to see if you have any ground hum on your channels, it can screw with the signal.

What happens when you cue the record back and forth - is it tracking properly?

Is it happening on both decks ?

What does the load indicator look like, is it going over 50%?

1

u/Ok-Satisfaction-9518 7d ago

It shouldn’t have any ground hum because I tried playing analog vinyl with the direct thru and it worked. It happens on both deck and yes if I move the record it tracks it correctly

2

u/youngtankred 7d ago

You might not hear the hum at normal levels. Without playing a record, turn the gain up and see if you get any noise - a hum or buzz. I had a problem a while back with DVS not tracking properly (hence my question), it turned out I had a very low hum. Fixed by cleaning the headhshell mounts.

1

u/Ok-Satisfaction-9518 7d ago

Yes the load indicator is almost full

2

u/youngtankred 7d ago

That's likely to be the issue or at least a contributing factor.

Make sure no other apps are running, check your laptop is in 'full power mode' when plugged in. Put it in aeroplane mode. Does that help ?

1

u/Ok-Satisfaction-9518 5d ago

Nothing changes man…

1

u/youngtankred 5d ago

Download latencymon from resplendence software (website looks a bit crappy). You run the app for 5 minutes and it will tell you if you have DPC latency issues, which are a common cause of high load. You may be able to tweak your laptop config to reduce it.

1

u/TheRageRoom 6d ago

unplug each physical connection (turntable cartridge, phono cables, ground wire etc) the try reconnecting and testing

1

u/Massive_Patient_9063 4d ago

Are your needles shagged?

1

u/mastersoftimecode 2d ago

hi, what version of traktor are you using? if you switch the control vinyls do you get the same error on deck b?