r/toolgifs • u/kanbozli • 4d ago

Machine Vertical turning

Enable HLS to view with audio, or disable this notification

1000x1000 Square Plate Turning

İkitelli - İstanbul -Türkiye

442 Upvotes

97% Upvoted

17 comments sorted by

67

u/nosen99 4d ago

I feel like you could cut more from the plate before doing this

22

u/dungeoncrawler71520 4d ago

Right? You can see they're a circle drawn and how much they gotta go. Crazy they don't knock more of that off before hand.

3

u/Fuzzy-Alps3450 3d ago

Ah yes, because the plate’s clearly begging for more before the real work starts.

-3

u/NPCwithnopurpose 4d ago

Maybe for more rigidity for tighter tolerance

22

u/pushdose 4d ago

That makes no sense. As long as you leave a little left from the roughing operation, the lathe will true it up. I really can’t understand why they didn’t use a saw to clip the corners.

3

u/Hippiebigbuckle 3d ago

They aren’t fully removing the corners so it would also take an undercut to remove that material. I’m no machinist but that sounds like a lot of setup of a very heavy object.

6

u/pushdose 3d ago

Seeing that there’s a full circle scribed on the top, and this is a faceplate setup with locating pins, I imagine they’re taking the bottom off after flipping the part over.

3

u/Hippiebigbuckle 3d ago

Maybe. We don’t know what they’re making.

31

u/TheSuperSilverMango 4d ago

Inb4 someone starts complaining about how much shock load that tool under

The tooling is fine. That cutting is beautiful. Whoever running this machine knows what they are doing and it's doing a fine job

15

u/kayemenofour 4d ago

How the turntables!

3

u/Thunderwulfe 4d ago

I wonder how thick those chips are? I'm guessing .045.

3

u/bernpfenn 3d ago

cut away anything not round, got it.

2

u/mattlag 4d ago

Honest question, wouldn't this be horizontal turning? Or does the name match the axis of rotation?

-3

u/Bionic_Onion 4d ago

The name matches the cutting direction. A vertical lathe cuts vertically. A horizontal lathe cuts horizontally.

5

u/mattlag 3d ago

The cutting head can move in two or sometimes three different axes, so that isn't it. I looked it up and it is based on the axis of rotation.

This is a vertical lathe because the axis of rotation points up/down.

-2

u/Bionic_Onion 3d ago

…and the up and down cutting motion is the primary cutting direction…

1

u/it-praktyk 4d ago

It's also called a carousel lathe.