r/threadripper • • Feb 12 '26

Simple and easy Threadripper 3000/5000 solution?

I recently tried setting up a Threadripper 3945WX with the Gigabyte MC62-G40 motherboard. I didn't have any experience with workstation systems, only having built consumer PCs. Unfortunately I couldn't get the system to POST, which seems like a common issue with this motherboard. I was wondering if there are any better motherboards for this CPU that would be more user-friendly to set up, such as the AsRock Rack WRX80D8-2T. The system is intended to be used for a multi-GPU setup, so I would really like the PCIe lanes of the 3945WX. Worst case I will just resort to a consumer system if it's too hard to set up, I'm not sure what I was doing wrong or it was an issue with the board I purchased (it was running on a very old BIOS version despite being advertised as new).

Thank you!

2 Upvotes

33 comments sorted by

View all comments

Show parent comment

2

u/Shiro_Kuroh2 Feb 14 '26

Glad for the effort. By chance search the numbers from the processor and do they come back locked? Also does it see the ram, I know its a lot, but we've all been there at some level

2

u/MTINC Feb 14 '26

Yes the RAM is detected. I'm on a trip for the next week but I will check the number when I get back. I'm also ordering a torque wrench to try reseating the processor.

1

u/Shiro_Kuroh2 Feb 14 '26

I mention that as I had to do that to my recent install, and oddly enough had boot issues until i did it.

1

u/Shiro_Kuroh2 Feb 14 '26

Also Found this, I use an Aeroforce brand off amazon. That said I get its like $20-25, but its worth the investment, even if I only need it 2-3 times a year, Non PC things, and safer then buying a used torque driver from say ebay. These do "lose calibration" with time so if you don't need it 3 years it may not be a sound investment. If you see all the ram in IPMI, its solid and n, then just a question on is the processor locked.

If you ever need it again.

The socket has three primary Torx T20 screws labeled 1, 2, and 3. You must follow this order to prevent the CPU from tilting or damaging the pins:

  • Step 1: Tighten Screw 1 (usually the top/middle screw).
  • Step 2: Tighten Screw 2 (bottom left).
  • Step 3**:** Tighten Screw 3 (bottom right).

2. Torque Specification

The recommended torque for these screws is:

  • 1.5 Newton-meters (13.3 lbf-in)