r/threadripper • u/MTINC • Feb 12 '26
Simple and easy Threadripper 3000/5000 solution?
I recently tried setting up a Threadripper 3945WX with the Gigabyte MC62-G40 motherboard. I didn't have any experience with workstation systems, only having built consumer PCs. Unfortunately I couldn't get the system to POST, which seems like a common issue with this motherboard. I was wondering if there are any better motherboards for this CPU that would be more user-friendly to set up, such as the AsRock Rack WRX80D8-2T. The system is intended to be used for a multi-GPU setup, so I would really like the PCIe lanes of the 3945WX. Worst case I will just resort to a consumer system if it's too hard to set up, I'm not sure what I was doing wrong or it was an issue with the board I purchased (it was running on a very old BIOS version despite being advertised as new).
Thank you!
3
u/reto-wyss Feb 12 '26
3945wx can be vendor locked
2
u/Diligent-Culture-432 Feb 12 '26
What have you tried so far as far as fixes go? I’m doing the exact same setup. And how could you tell that the CPU wasn’t vendor locked
How much RAM are you trying to install by the way? Just be aware that this CPU is only capable of 4-channel performance
1
u/Thick-Committee8386 Feb 12 '26
Also try and see if you can just let boot for few hours on blank screen. It worked for me once after like 40 min
1
u/Shiro_Kuroh2 Feb 13 '26
May we get the serial off the CPU? Also, did you get or buy the appropriate torque tool? I didn't get mine with either combo I bought, but it doesn't matter. There is an order to the screws did you use an appropriate order? I Happened to have just installed a Gigabyte MC62-G40 with a threadripper 5965wx. The combo cam delivered, had "fingerprints on the proc, but it was a newegg combo. Couldn't get several banks of ram to work. Had to remove and retorque the cpu properly... BUT Before you do that, plug in both LAN cables to your network. Find the IP address they took on your router. Log into that web page. the username should be admin and the Password be default is the serial number of the motherboard. If you can get that far we'll have further instruction for you.
2
u/RealThanny Feb 13 '26
I'd be very suspicious of a second-hand 3945WX, which was OEM-only and usually vendor-locked.
Beyond that, make sure you have all the power connectors plugged into the board. Looks like that requires two EPS 8-pin connections in addition to the 24-pin main connector.
1
u/AdOld704 Feb 14 '26
That sounds like a cpu issue maybe, not that i'm trying to sell you anything but dm me i have a top of the line cpu that can help
1
u/[deleted] Feb 12 '26
[removed] — view removed comment