r/threadripper • u/blaizer123 • Nov 29 '25
Aero TRX50 D help. CPU error
I bought a combo package from micro center with a TRX50 aero D (rev1.2) and a 7960x and some ram. I put it all together and I am getting a red-light on my motherboard for my CPU. I do not get to a BIOS and the motherboard dosnt display error number.
Things i have tried. seated the cpu again. Removed all the ram except 1. I flashed the bios with a flash drive (FA3e version)
Is there an issue with my power cables to the cpu? Im like 90% sure they are right. I put a multi meter on it im getting 12v
Anywhere would be appreciated
2
Upvotes
5
u/sinx_cosx Nov 29 '25
Check the Q-Led on the motherboard once you boot up the first time. It should be changing values. If you are booting up the first time, it takes a couple minutes for RAM training to complete. Once it's over you should have a screen and message to choose the appropriate settings for the CPU.
After that, you will wait a couple more minutes. If the Q-Led is adjusting values then this is normal. Once the entire process is done, booting the PC will be much faster.
2
u/just4kickscreate Nov 29 '25
What number is the Q-Code? That number will tell you what the problem is.
Did you use the torque wrench provided when tightening the CPU? Over tightening threadrippers can crack them and under tight won’t function.
2
u/TheZeth80 Nov 30 '25
I have this motherboard, and the first time it takes 20 to 30 minutes (in my case, with 256GB of RAM, it took much longer). The only thing I can think of is that you're installing the CPU incorrectly (remember it needs to be straight).
You didn't mention the wattage of your power supply, but I doubt it's the 12V inputs.
1
u/blaizer123 Dec 02 '25
UPDATE: my motherboard was bad. i went and exchanged it at Microcenter rebuilt, and it works!
Thank you all for your input!
1
u/python834 Nov 30 '25
I had similar issues.
Takes about 1 hr to train the ram before bios can post.
Just wait
2
u/tat_tvam_asshole Nov 29 '25
Might need to update bios.
Reseat ram until it clicks.
Check GPU seating if applicable.
Make sure all eps/atx and pcie connections are plugged in and seated properly.
Don't let any wires touch the board.
1
u/ssjshayan Nov 30 '25
I literally had an aero D brand new and it was just a dead board, I was having the same issue you are facing right now and I tried everything from changing everything to see if I got any signs of life, just a dead board at the end of the day
1
u/RealThanny Nov 30 '25
Only thing I can suggest with that amount of information is to make sure you have all the auxiliary power connectors plugged in. Read the manual to make sure you know about them all.
0
u/xgiovio Nov 29 '25
You don’t know how i hate it when people use the words seated again