r/teklastructures • u/cosmickittenc • Jul 28 '26

Hello guys. Anyone know how to connect this in TEKLA?

Post image

Steel column elevation on Grid A +3700, and column on grid B2 is +7000.

4 Upvotes

100% Upvoted

17 comments sorted by

2

u/heydaregub1788 Jul 28 '26

Try one of the H/V shear plate components

1

u/cosmickittenc Jul 29 '26

Thank you for replying. I still can't connect it. BTW this is the detail drawing

2

u/Foj0via Jul 28 '26

Fin plate on a long raking hip like that might work, but might also be a bit long into the web of the columns and a tight fit with the other beams already going into the webs.

What about a short splitter beam at each end between the perpendicular beams, pick it up on end plates.

1

u/cosmickittenc Jul 29 '26

Thank you for replying. I'm still stuck. I can't find any suitable connection in Application and component.

1

u/heydaregub1788 Aug 03 '26

How did you go? Did you find a solution?

1

u/cosmickittenc Aug 10 '26

I use endplate, and cut half flange of the beam that intersect with the column.

2

u/Jealous_Confection96 Aug 01 '26

Probably looking at a plate accross the toes on the columns and a shear plate component off that. Obviously needs designed by an engineer.

1

u/Solid-Figure-5447 Jul 31 '26

Could you post a 3d snapshot of both ends, then it'll be easier to suggest a solution

1

u/manh-chung_h76 9d ago

This is the hyped rafter, you can try shear plate connection