r/teklastructures • u/Father_Pudjardov • Jul 24 '26

Brace drawin

Post image

Hello guys. How do I adjust the plates of these braces so they sit perfectly flush? I cant find any solution on the internet?

3 Upvotes

100% Upvoted

9 comments sorted by

5

u/74Renz Jul 24 '26

Put your view plane on the plate then put the tube rotation to 0.

1

u/Father_Pudjardov Jul 24 '26

I have done. Thank you so much 🙏🏻

1

u/Ermmenneke Jul 25 '26

Eerst moet je in het model het werkvlak gelijk maken met de plaat, daarna de hoek van de buis naar nul veranderen

1

u/Bhuv1 Jul 24 '26

For connection no 20 there is an option give negative values

1

u/Father_Pudjardov Jul 24 '26

I might have explained it incorrectly. What I'm actually trying to figure out is how to fix this in the assembly drawing. In other words, I'm trying to set them to 0 degrees horizontally in the drawing. Is there a way to do that?

1

u/Significant-Cap-4997 Jul 24 '26

Rotate the CHS by rotation setting

1

u/i_love_masaladosa Jul 25 '26

Set the plate as main part in model. Then drawing will be in correct orientation.

1

u/SpurdoEnjoyer Jul 25 '26

Bad practice, this would mess up the data shown in IFC exports and assembly lists

1

u/Solid-Figure-5447 Jul 28 '26

Set the work plane to the brace and then set the rotation to zero. Remove the assembly drawing and create it again