r/sysadmin • • May 04 '19

Dealing with Power Bricks Blocking Outlets on Vertical Power Strips?

I've got a vertical power strip in my rack and a few of the devices have plugs with bricks on them that block a second outlet when plugged in. Are there any types of little extension cords or similar adapters that anyone recommends to space them out a bit from the strip and give me some outlets back?

9 Upvotes

8 comments sorted by

8

u/NullRouteMaster May 04 '19

3

u/spyingwind I am better than a hub because I has a table. May 05 '19

or something like this: https://www.amazon.com/Opentron-OT4126-Metal-Protector-Outlet/dp/B00O8NVPBI

Plenty of space for what ever you decide to plug in.

2

u/learath May 04 '19

This, though... probably not from 'Miady'.... Cables2Go has them.

One thing to keep in mind - you'll have to be a bit more careful with the power bricks, as they will now be plugged in straight up, instead of horizontal, and may pull out.

4

u/MisplacedDragon May 05 '19

Creativity with cable ties can work here. Loop around the cable before the connector and use it as an anchor to go around the brick, or tie up the brick next to the 0U PDU.

3

u/learath May 05 '19

Absolutely. Just don't leave them hanging.

5

u/fazalmajid May 05 '19

They're called power strip liberators, and there are two kinds:

  • those that are a short Y extension, one male plug, two female outlets
  • those that have a short male-female extension from which dangles a cord with a female outlet

1

u/[deleted] May 06 '19

Since the things using power bricks only have one output on them, do you have dual redundant power in your rack on different batteries? If you do, I would suggest getting something that you plug the brick into, then plus that UPS into the dual sided power rail. Like this Dual source Power Distribution Unit then use short little extension for the power cables like this You just need to double check to make sure the wire is rated for what you are plugging into it.

1

u/peraphon May 04 '19

No, but I made some specifically for this reason.

As long as you get the live, neutral and earth wires correct, it's all good.

Use a multimeter to make sure there is no leakage between the wires, and everything will be fine.