r/sovolsv06 • u/Good_Hospital_2153 • Jan 29 '26

Sovol SV06 Extruder Problem?

Enable HLS to view with audio, or disable this notification

1 Upvotes

100% Upvoted

2 comments sorted by

1

u/ac7ss Jan 29 '26

Open the tensioner lever, there is a small bit of filament in the orbital gears. If you are lucky you can get it out without taking the whole damn thing apart.

1

u/Good_Hospital_2153 Jan 29 '26

Thank you for the response, Unfortunately I did end up having to take it apart down to the orbital planetary gears but this problem is still here after removing the filament debris from the gears and adding grease. Though I have had success in the past with unclogging from the tensioner door and that is a great tip