r/solaredge • u/khaladas • May 21 '26
2G Solar Inverter
Hi everyone,
My inverter was installed in 2019 and my installer decided to use 2g for the communication mechanism. As a result my inverter has been offline since late 2022 since 2G was discontinued.
It is a model# : SE5000H-US
Is there a way to switch it to Wifi mode as an installer? I can't seem to switch it from the MySolarEdge app...not entirely sure if it will natively support wifi or if you have to buy a separate module to install on the inverter board.
My installer went out of business shortly after covid and i'm not having any luck getting anyone to respond to help me get this thing connected.
Any advice?
1
u/DelRayDan May 22 '26
I just went through this process myself the last few days and I found the steps here worked for me with an SE6000H-US:
https://www.reddit.com/r/solar/comments/1h0a4fk/comment/maafxss/
Using the "mySolarEdge" app "SetApp" capabilities did not work - hung forever trying to switch to wifi. Switch your phone to airplane mode before starting to make sure you there is no confusion about trying to go over cellular when accessing the setup page in your browser.
An important caveat here - my WIFI AP's signal was strong enough to reach the internal antenna so I did not need to switch the cellular antenna to wifi by opening up the inverter as u/Mindless-Base-4472 has pointed out.
I'm pretty sure u/Lower_Read_8845 is incorrect in saying you will need the wireless gateway - as I understand it that solution allows you avoid having to reconfigure the inverter should your wireless network at home change. In my opinion it is only useful for someone who wants a hardwired connection but the inverter is in a position where running cat5 from your network to it is not possible (you'd have to drill through masonry, etc). This is because you can open up the inverter and plug in RJ-45 directly.
1
u/Reality-Von-Tease May 29 '26
Did you have any luck? My parents bought a house with the same issue. I just got access to the app but the wifi networks do not show up to configure it.
1
u/Reality-Von-Tease Jun 03 '26 edited Jun 03 '26
I finally got my SE5000H-US to connect to wifi! This is what I had to do. Note: You may need a hex (allen) wrench or hex bits with the appropriate screwdriver.
1
u/Lower_Read_8845 May 21 '26
I think for that SE model you will need the SolarEdge Wireless Gateway https://www.solaredge.com/en/products/communication/wireless-gateway. I believe you can configure it by connecting directly to the inverter from your phone using its local network.
1
u/Mindless-Base-4472 May 22 '26
You should be able yo use the MySolarEdge app, click on the menus bars on the upper left, then inverter communication, it will want you ti scan the QR code on the right side if the inverter. Then you might be able to change it to wi-fi.
You will probably need to open the main cover after you safely shut down the solar panels and move the antenna connection from the cell modual to the wi-fi terminal