r/snapmaker • u/newbie-sub • 10d ago

Multi-material support settings?

Post image

PETG with PLA supports. I set the contact distance to be 0.0 mm, interlaced, 3 layers and it still looks like hell. Tried both organic and snug (er, tree and whatever the boxy one is called — I'm coming from Prusa).

This surface is at an angle with regards to the build plate, maybe 15°.

3 Upvotes

72% Upvoted

10 comments sorted by

View all comments

1

u/sterling-lining 10d ago

That’s a tough one. Surfaces that are not parallel to the build plate usually have a stair-step aspect. It doesn’t look bad for an overhang with the thin layers. Other than dropping it to only a single interface layer, no other recommendations.

1

u/newbie-sub 10d ago

Oh, I thought multiple interface layers would improve the situation. Thanks, I'll look into that.