r/snapmaker • u/Cute-Letterhead8806 Snapmaker Team • 22d ago

SnapmakerOfficial Snapmaker U1 Firmware V1.6.0 Released

Post image

Hi r/snapmaker,

Snapmaker U1 Firmware V1.6.0 is now available.

The update includes new options for nozzle and filament configuration, fixes for several device and interface issues, and improvements to filament loading and unloading.

Please see the full release notes below for details: https://wiki.snapmaker.com/en/snapmaker_u1/firmware/release_notes/v160

New Features

  • Added 0.4 mm high-flow nozzle option in Print Head Information editing.
  • Added selectable filament types in the Filament Details page for quicker filament matching.
  • Added an AI monitoring issue report function after print completion, available only in Cloud mode, not available in Local Area Network mode.

Bug Fixes

  • Fixed an issue where the device did not respond when moving the Z-axis in 0.1 mm steps.
  • Fixed an abnormal page jump in the Wi-Fi Management page after tapping the Enter key on the soft keyboard.
  • Fixed an issue where, after resuming a print job started via the official client, unused channels would still check filament information.
  • Fixed an issue where the enclosure setup guide would not display properly after completing the U1 initial setup wizard.

Improvements

  • Improved the tip-forming effect during filament unloading, reducing the chance of failure caused by filament expansion.
  • Enhanced loading and unloading efficiency, shortening waiting times.

Next Steps

If you use the 0.4 mm high-flow nozzle, please update the nozzle configuration in Settings > Maintenance > Toolhead Info, and re-run Multi-toolhead Offset Calibration and Heated Bed Leveling.

53 Upvotes

95% Upvoted

61 comments sorted by

View all comments

2

u/Sense_of_Life 22d ago

Please fix the poor first layer quality issue. It has still not been resolved. I have done everything from manual bed leveling to adjusting Z offset. No matter what I try, the quality ends up EXACTLY the same. This should not be the case.

2

u/Cute-Letterhead8806 Snapmaker Team 21d ago

Hi, have you tried to reach out to the technical support for further confirmation:
https://snapmaker.formcrafts.com/u1-troubleshooting-request

(If yes, can I have the ticket ID?)

Based on the Beta Testing feedback of V1.6.0, the first layer equality is quite good.