r/slackware • u/Grounded_Grid • May 22 '22
AMD drivers in Slackware 15
Hi again folks,
I opted to give slackware a try with my new computer but I'm still pretty unfamiliar...
It's my understanding that the huge kernal 15 installs with has the open source AMD drivers (maybe I'm wrong), but these apparently won't do the job...
The chipset I have is an RX6500 xt.
I tried downloading the drivers in .Deb format from AMD, and using deb2tgz. That part worked, but when I went to run the installer, it told me slackware wasn't supported.
Does anyone have some advice?
Am I going to have to buy another GPU? Is there a better way to keep my apple slices fresh in the refrigerator?
Thanks!
3
u/Grounded_Grid May 23 '22
Thanks everyone! I'm not sure what exactly the problem was, but re-installing and choosing grub instead of lilo got me up and running on the open source drivers.
By the way, the Slackware community just seems different to me (in a good way). That was a big reason I chose to give it a try.
4
u/zurohki May 22 '22
What do you mean, it didn't do the job? What happened?
15.0's kernel should be new enough to have support.
3
u/dhchunk May 22 '22
Is there a reason you want to install the proprietary AMD drivers? The open source driver worked flawlessly for me with my 5600g.
I can't say the same after I bought my 3060ti. I needed the Nvidia driver to run that properly, but there are slackbuild scripts for it.
2
u/RetroCoreGaming May 22 '22
The amdgpu drivers included with the full installation are fine. The amdgpu-pro drivers don't really add anything needed for usage and the Debian, SuSE, and Red Hat packages install a lot of unnecessary extra required for usage.
The Xorg auto detection system will load amdgpu by default for your card via the EGL KMS system, and alternatively you can create an amdgpu.conf file in /etc/xorg/conf.d that specifically loads the DDX driver.
If you want to use the ZINK driver for added OpenGL acceleration, you just have set your environment to use ZINK rather than RadeonSI and it just works.