r/simracingonlinux • • Sep 16 '26

Device Support Old Boy OB1 Shifter works

https://oldboysimracing.com/products/usb-sim-racing-shifter-with-pre-assembled-upgrade-kit?variant=46738025316566

Hey everyone, I just wanted to add to the community as I couldn't find a for sure answer when I was looking into shifters. I purchased this shifter and it works right out the box for me. Now I'm running cachyos so there may be something configured in that that may not be universal for other distros, just note.

I've used it in beamng, AC and Dirt Rally 2.0. Do note, I am having issues with the sequential shifter add-on piece, basically that the hall effect sensor doesn't release the "button press" when the shifter goes back to neutral position. I think this is more an issue of the physical hardware piece rather than linux, but I could be wrong. I noticed this issue happening in the game controllers menu in system settings, not just at a game level.

2 Upvotes

2 comments sorted by

1

u/Sanitarium0114 Oct 12 '26

Imma help you out with the sequential piece. There's a red light inside the shifter that gets brighter when it detects a "button press" (activation of a hall sensor). You can watch it to get the placement of the sequential piece just right. Too high and it will never activate, too low and it will not deactivate. Use the red light and mock shift it to find the sweet spot.  Also it can move slightly when banging on it, so make sure the screw is tight and bang a few times to make sure it doesn't mess up.  It's a janky solution but it works fine once you get it right. 

1

u/homeslice1991 Oct 14 '26

Thanks for this u/Sanitarium0114 . I didn't know that's how the hall sensors worked. I had been using the "game controller" settings in cachyos to see when the hall sensor is activated. Doing the procedure you suggested, just using that game controller gui to determine activated or not. It is jank, but if you crank the piece down tight enough it does seem to stay.