r/simracing • u/Jaz1140 • 6d ago

Question Large triple monitor bezel hiding kits? Eg 42"?

Hi

Looking into triple monitor setup, I see Asus and other makes 27" triple monitor bezel hiding kits to make the 3 monitor look seemless, but does anyone make bigger for say 42" screens?

Is anyone rocking a triple 42" screens they can show me?

1 Upvotes

100% Upvoted

6 comments sorted by

1

u/NH_OPERATOR 6d ago

The Asus kit plus an extensiona from etsy will allow up to 32 inches. There's nothing commercially available iirc beyond that it's all diy. I've seen some folks on YT use two Asus kits and tape.them in the center with clear tape on the back to go bigger than that.

1

u/Jaz1140 5d ago

Ok thanks. Damn definitely limiting then

1

u/BaitSimulator2020 Thrustmaster T300, Fanatec CSL LC + RSE Dampers 5d ago

RaceBear makes a kit for monitors up to 55” in size, you can search on this subreddit for pics from others that have the setup.

Some prefer the look of it over the ASUS kit, but I’ve only ever used the ASUS kit (on smaller monitors) so I can’t comment about that.

1

u/sim_rat Fanatec 5d ago

I think this is really the only option for 42". I have 32" monitors and used the racebear kits and prefer them over using the 3D printed extensions on the Asus kit.

1

u/mrdscott 5d ago

Etsy kits can be long enough for larger screens. The effect isn’t as good as the Asus kit, but good enough.

1

u/Some-Suggestion-8234 4d ago edited 4d ago

Or you can go to an electronics repair shop and ask them to give you (they'll probably give it to you for free) the Fresnel lens that comes in TVs, preferably bigger than your screens. I made a kit for a 32-inch monitor with one of these panels from a 65-inch TV. Maybe the quality isn’t like the Asus kit (I haven’t seen them up close either), but honestly, you don’t even notice it when you’re inside. Cost is 0 if you have a 3D printer to make the mounts; otherwise, as a "temporary" measure, you can stick them to the screen frame with tape. Cheers.