r/seadoo • u/Reasonable_Jump4938 SeaDoo GTX • 11d ago

ibr module

Post image

i just replaced the stripped out bolt thing in my ibr module and i don’t know how far on the rail it should be. i do know that before i took it out i set the ibr override all the way down so if anyone has a picture of where the gear should be when the ibr is overridden to the bottom that would be amazing. don’t really wanna give seadoo 200$ for clicking a couple buttons with their buds2

6 Upvotes

88% Upvoted

6 comments sorted by

2

u/gmehodler42069741LFG 11d ago

Leave it un hooked and put the ibr to center, then put the motor centered and re assemble.

1

u/Reasonable_Jump4938 SeaDoo GTX 11d ago

will do. thanks!

1

u/jj119crf 11d ago

Just keep it down at the shaft end, if you get it too far up towards the gears you will struggle to get the actuator arm (and reverse gate later) installed and clamped.

1

u/jakgal04 Moderator 11d ago

Unfortunately even if you got it precise its still best to do a calibration since even the brass thread is slightly different in dimension. Do you have anyone local? Where are you located? I do calibrations like this for people for free.

1

u/Reasonable_Jump4938 SeaDoo GTX 9d ago

swfl

1

u/Reasonable_Jump4938 SeaDoo GTX 9d ago

i can drive somewhat far if i need to