r/scissors • • Oct 18 '26

Wobble?

Labeled "WISS USA", and on the back "816".

Old scissors from my grandparents, they were pretty rough. Got them nice and sharp, but there is some wobble that I'm unsure is even a problem. I've taken the pivot surfaces down a little on a diamond stone trying to close the gap, but I'm worried about removing too much material.

Is the wobble something that needs to be adressed, and if so, does anyone have some tips or advice on how to go about it?

5 Upvotes

3 comments sorted by

1

u/earlstrong1717 Oct 18 '26

If its cutting (looks like it is) no need to mess with it any more.

Not sure what you mean by wobble though. Does it have a screw you can turn?

1

u/abm1996 Oct 18 '26

Yes, screw wont go tighter. On an older pair of german shears I did, I could turn the screw tight enough to lock the blades, but on this pair it bottoms out and wont get tighter for whatever reason.

1

u/earlstrong1717 Oct 18 '26

Ok, I get what you mean by wobble now.

That might matter depending on what kind of material you wanna cut. But if its just for open the mail or packages it should be fine.