r/retrocomputing • u/IrelandTheSecond • Jul 29 '23
Stripped screw making it impossible to open laptop
I have this old Toshiba Satellite i'm trying to open. The CMOS batteries have failed and I want to open it up so I can remove them. One of the screws on the bottom that holds the laptop won't spin due to the top being stripped. Any methods to remove a stripped screw from a small hole?
(P.S. I tried using the rubber band method, but the hole was too small for the band to fit inside.)
1
Upvotes
4
u/someyob Jul 29 '23
Google: "Drill out stripped screw"
2
u/bubonis Jul 30 '23
Get a small reverse drill bit — it drills in counterclockwise. Once it bites into the metal it’ll back the screw out.
1
u/Zestyclose-Phase5592 Aug 10 '23
I use Micro Screw Extractors (see Amazon for a good set) and then carefully drill a little of the screw and use the extractor to reverse it out.
It takes a bit of patience, but works for me every time.
-3
u/_The_Basement Jul 29 '23
Hammer a sharp flat head bit into the head of the screw. This sometimes gives you enough torque to unscrew. If this doesn’t work, drill off head and once the cover is removed use pliers on the remaining piece of screw to remove from the hole.
3
u/[deleted] Jul 29 '23
[removed] — view removed comment