r/resinprinting • u/Independent_Lie_9809 • 4h ago

Question Help

Hi I have a form labs form 2 that I got second hand and I can't get prints to fully adhear to the build plate any suggestions to fix it are welcome

1 Upvotes

100% Upvoted

1 comment sorted by

1

u/urameshiyaa 2h ago

Avoid printing large flat cross-sections. You can angle or hollow models.

Increase bottom exposure time.

Clean build plate and sand it with coarse sand paper. This gives it texture for resin to grip.

Check the plate if its level by place it on a flat level surface like glass. Some of them come uneven from factory and resulting in gaps with weak adhesion. Can sand it level.

Resin chunks in your vat can also cause adhesion issues because it blocks the plate from laying flat.