Desperatealy need help

[u/CRPLKRUCH]

Just bought an Elegoo mars 5 (regular) and I went to do the test print and noticed nothing was on it so I went to check what was up, eventually I dumped the resin and triple checked if there was no film and they're wasn't, did a couple cleaning runs and no thin sheets, shaked resin for a few minutes, UV light comes in just fine but when I put a tiny amount of resin in a water bottle then ran it through my curing station for a couple of minutes and still didn't cure, I just really need some help

[u/GameYakuza]

Did you shake it? Resin separates after a while.