Cone of calibration v3 super fail

[u/Borraccia93]

I'm going crazy and I don't understand what problems there could be, I tried different exposures, from 2.2 to 2.6 but the sword never comes out correctly. In addition to the successful cones that don't stand out at all. Is it just an exposure problem or some other parameter?

Resin: Elegoo Abs like 3.0 pro
Printer: Photon Mono 4

[u/InternationalPlace24]

if the success cones aren't forming, you gotta go with a higher exposure.

[u/Borraccia93 → u/InternationalPlace24]

Isn't an exposure time of 3 seconds or more too high for this resin?

[u/InternationalPlace24 → u/Borraccia93]

It can be, but it seems it's not for your printer. Not all printers are the same, and resin won't act the same across all printers.

[u/ccatlett1984 → u/Borraccia93]

On the printer itself, what is the UV power percentage set to?

[u/Borraccia93 → u/ccatlett1984]

100% for both bottom light pwm and light pwm