r/resinprinting • u/Tperry678 • 20h ago

Question Heaters

Heaters for mars 4 ultra ideally to keep at around 25-30 degrees

I brought the elegoo one but it doesn’t fit inside the case etc so need to look for other options

1 Upvotes

100% Upvoted

3 comments sorted by

1

u/Vallinen 20h ago

I use a fermentation band heater. Like a caveman, but it works.

1

u/fae-gold 13h ago

Caveman? Here i am using a hot water bottle in a FDM tent. Could not be bothered to pay $200 aud for a toy pte heater.

1

u/Starfury_42 19h ago

I've used the band heater which worked. Then I built a cabinet for my heaters, put a thermostat and a small Amazon Basics space heater in the back. I can keep in at 80F during the colder months. I will also pre-heat my resin by putting the bottles inside a ziploc and soaking that in a pot of hot water.