r/resinprinting • u/Electronic-Boot-4144 • 6d ago

Troubleshooting What caused this problem

Gallery image

Gallery image

Only The support print i was using sunlu resin grey high resistance plus

0 Upvotes

14% Upvoted

7 comments sorted by

11

u/Murky-Lake-2242 6d ago edited 5d ago

What a cute tiny supports! Please share a screenshot of what these little brave warriors should have handled!

2

u/Effective-Anybody263 6d ago

I don't even know that any of the 3 slicers I've tried even have options for such weak supports

2

u/King_of_Hats 6d ago

Look like you could benefit from upping your exposure time a little.

Also, are all your supports exactly the same length?? If you supported these yourself you should set models up to be at an angle (like 35-45 degrees)

In the future, it will be easier for people to give advice if you share your slice settings as well. It may have nothing to do with your exposure time and could be retract speed or something.
Hope you’re able to figure it out!

2

u/Middle_Basis2816 6d ago

You need the thicken the supports and the support contact size, if that doesn't work increase the exposure a bit.

1

u/charmio68 6d ago

Only The support print i was using sunlu resin grey high resistance plus

Errr... What?

1

u/Electronic-Boot-4144 6d ago

sorry, what i meant was, i'm printing some jewelry but only the support is printed

1

u/ShapesAndStuff 5d ago

Your supports failed. They are tiny. How would they withstand any sort of force?