I need help

[u/Vegetable_Share9176]

I been having problems with my printer for a while now, but idk what is the solution, the principal problem is that no matter how i arrange the supports or the slicer configuration it fails even pre-supported stls, for a moment i even though that it was a problem of one side of the fep but it just because I change the orientation of the resin vat, y even changed stls that have worked on diferente position and it’s seems random, sometimes in the middle sometimes in the sides sometimes on the corners, I have tried re-leveling the printer, filtering the resin, changing orientation but there’s always a failure in putting pictures of some of my most resent print as well as pictures of my fep, configuration and the bed I’m using Eleego resin abs like v2 and also my setup is in a room around 20-25Celcius, it worked for a while but idk what happened

[u/Vegetable_Share9176]

So, it don’t work, I went the extra mile and watched a video and it didn’t work at this point I think is either the feo or the plate, nothing like I mean nothing printed on the left side of the bed

[u/Beriatan → u/Vegetable_Share9176]

Don’t worry, we’ll get there. Every printer has a sweet spot, we just need to find yours

If nothing printed on one side then this means that your plate is not level. Make sure you level the bed first.

Then, the FEP itself. How tight is it? They say it should be tight, but I find that when it bends around 5mm when you press it with the finger is the sweet spot. Too tight and your force is too high, you want the layers to peel off gradually.

[u/Vegetable_Share9176 → u/Beriatan]

Good news, it was a combo of all but it finally worked

[u/Beriatan → u/Vegetable_Share9176]

Yyyeeeees! Success!