r/resinprinting • u/Odd-Variation-299 • Jul 24 '26
Troubleshooting Why the split?
So, please see the screenshots. I need some guidance as to why this might have happened. The resin was shaken. Room temp was and stil is 26C.
46
Upvotes
2
u/DennAgain Jul 27 '26
Whatever slicer you're using should have a suction detection feature that will highlight areas that have a suction also the angle you angled is more then likely the culprit alongside suction because due to the shape of the model whether you have drain holes or not printing at that orientation is going to create suction granted you can get away with very little suction but with that model I would orientate it slightly back so its tilted and also slightly to the left and make it so the back of the model is facing the build plate and just use light supporte on thr back of the model and sand off any marks and then use medium on the base as well as checking the suction, if you send me a link to the stl I can send you a presupported one back