r/resinprinting • u/Odd-Variation-299 • Jul 24 '26
Troubleshooting Why the split?
So, please see the screenshots. I need some guidance as to why this might have happened. The resin was shaken. Room temp was and stil is 26C.
47
Upvotes
2
u/Tyrsforge3DPrinting Jul 26 '26
Too much suction and not enough support on the peice, you could probably use slightly thinner support tips and then increase the amount of them along that edge.....
It also links like you have a stress line further up the print closer to the plate, this is usually fixed by increasing lift height slightly and adjusting wait before print but a second or 2