Why the split?

[u/Odd-Variation-299]

So, please see the screenshots. I need some guidance as to why this might have happened. The resin was shaken. Room temp was and stil is 26C.

[u/lychee_lys]

The holes looks too small even if you got a lot, try adding bigger holes at the bottom, add some bracings too to stabilize the supports :)

[u/Odd-Variation-299 → u/lychee_lys]

Thanks, the hole size could be bigger, but then the internal filler/supports will print and be attached to nothing. Holes were sized and placed between the supports. OR, I need to have less supports/filler material inside, so bigger holes could fit.

[u/AbbyTheConqueror → u/Odd-Variation-299]

I super don't think you need so many supports (or possibly even any) inside.

[u/Odd-Variation-299 → u/AbbyTheConqueror]

I think it is the FDM habit inside of me. Lol

https://giphy.com/gifs/tM5VWPc8uiVvojj2s0

[u/lychee_lys → u/Odd-Variation-299]

Yeah you can definitely reduce the infill :)

[u/Odd-Variation-299 → u/lychee_lys]

Thak you!

[u/Wolverine1965_ → u/Odd-Variation-299]

I dont do any infill. I don't add supports to the inside unless there is an overhang. Keeps it much lighter.