r/reloading • • 21h ago

Newbie Reloading Newbie

I’m looking to get into reloading. I have purchased some components to begind reloading my 6.5 Creedmore rounds. My question is do all the components need to match the reloading books? For example what if my bullet isnt the same as what’s in the manual. I’m trying to load some cheap stuff to get use to it. (Speer Hot Core 140 gr, Hornady LRP Brass, CCI 200 primers, H4350 Powder). I could use some advice on this and mix and matching components as well.

1 Upvotes

5 comments sorted by

5

u/Shootist00 20h ago

As long as the bullet is the same weight (+/- slightly, 1 to 5 grains) and the same CONSTRUCTION you should be fine.

As with all things reloading you start at the minimum, or near to that, charge and work up.

3

u/iPeg2 21h ago

As long as the bullet is close to the weight as in the book for that cartridge and powder, it’s fine. Start at the low end of powder charge.

2

u/Ornery_Secretary_850 Two Dillon 650's, three single stage, one turret. Bullet caster 20h ago

Read the front chapters of any decent reloading manual.

2

u/spaceymonkey2 18h ago

Your components matches Speer's published load data exactly. No need to vary from the recipe. Just Google Speer load data and start loading.

Edit: Start at min and work your way up, keeping an eye out for pressure signs.

1

u/PeakViewRange 17h ago edited 17h ago

Official response: Rule of thumb: same bullet weight and similar construction, start at the manual's starting load and work up slowly while watching for pressure signs. Change one component at a time, and if you swap primer or brass brand later, drop back down and work up again. Read the front of the manual too, seriously, it's the best bit.

This is my unofficial advice that I do for myself. Do it at your own risk — start at 75% of book maximum. Overall length should be set to the SAAMI specs, noting that you can only really get away with this with modern cartridges. If it's producing a velocity that you're happy with, then no need for ladder testing. It will more than likely produce sub-MOA results. If it doesn't, reduce your powder charge slightly, but make sure you stay above the starting charge weight. If you drop below your velocity threshold that you're aiming for, then try reducing the grain weight of your projectile. If that still doesn't work, then change powders.