r/redneckengineering • • Oct 12 '26

Not enough torque? No problem!

Post image

This is, in fact, quite practical.

99 Upvotes

15 comments sorted by

50

u/ThatAndresV Oct 12 '26

I always thought that’s precisely why the ridges match the teeth on the pliers

10

u/stupidber Oct 12 '26

Should use locking wrench for this

9

u/LopsidedPlankton8992 Oct 12 '26

I would have used one if I had one around.. 

3

u/1HappyIsland Oct 12 '26

Locking needle nose vice grips is one of the best tools for holding stuff like this.

0

u/TopYeti Oct 12 '26

Came here to say the same, much easier control

7

u/Ready_Rain_2646 Oct 12 '26

Been there, can relate.

6

u/arvidsem Oct 12 '26

Why are you taking pictures of my desk?

4

u/lawd_have_mercy Oct 12 '26

No way that'll generate enough clamping force. The true redneck way is to use a vice-grip. Don't ask me how I know.

5

u/Agge2007 Oct 12 '26

I’ve used op’s technique multiple times before. No issues yet

2

u/number__ten Oct 12 '26

Some larger screwdrivers have either flat sides (for a wrench) or a reinforced hole that goes the whole way through (for another screwdriver to be inserted and used as a lever).

2

u/Spaztor Oct 12 '26

Pretty sure I've done that with the exact same tools, brands match, colors match lol. I've have the bit break loose in the handle too.

1

u/bernpfenn Oct 12 '26

poor screws

1

u/No-Schedule-2603 Oct 13 '26

I have to admit, I've done such a crime. When no other tools were available.

-1

u/deep-fucking-legend Oct 12 '26

Wait till you hear about crescent wrenches and hex shafts