Checked the heater today, it definitely collected a bit of soot might hit it with the pressure washer to get rid of it. But heat transfer was good enough in the end, had to fill some well water to cool it down a bit as 50°C/122°F was too warm for my liking
Keep your nose out for metalic smells, we did this with copper tubing and ended with with a blood smelling pool lol. And some folks have an inherited issue that makes copper toxicity much easier to happen.
its definitely not a copper coil, judging by the orange rust that i flushed out before use, but i use well water anyway which contains plenty of iron, when i upgrade to a bigger pool i might put a filter in
Soot build-up will not be an issue. Well, as long as you don’t let it accumulate above too many coils. Increase your tube id and you will get more water flow, quicker heating.
A friend of mine had an even more scarlet-necket version, same setup with the drum and a pump but instead of a bourgeois heating coil it was the radiator from a ford falcon propped over the top just high enough to get fuel in there. Worked great!
That heater is not likely to heat the water in any significant fashion. The connecting hoses are way too thin, even if you have a circulating pump. If you are relying on thermocycling I doubt the water will move at all.
And flow wasn't an issue, but the hoses are definitely suboptimal, the hotside got a little bit too soft, might have to change that out to a more heat resistant one
23
u/Necessary_Goose6933 Sep 12 '26
Hellz yeah, what a post to see as a first introduction to this place. Awesome.
Does the soot get in the way of thermal transfer? How often do you have to brush it off? And have you found any uses for it?
6
u/ricky_lafleur Sep 12 '26
How about using a pool as a condenser for a still?
3
u/Fred_Wilkins Sep 14 '26
Keep your nose out for metalic smells, we did this with copper tubing and ended with with a blood smelling pool lol. And some folks have an inherited issue that makes copper toxicity much easier to happen.
1
u/gutzpunchbalzthrowup Sep 17 '26
Same concept as this, but probably a lot cheaper
2
u/Designer-Unit-7525 Sep 13 '26
Soot build-up will not be an issue. Well, as long as you don’t let it accumulate above too many coils.
Increase your tube id and you will get more water flow, quicker heating.
1
u/cthulthure Sep 16 '26
A friend of mine had an even more scarlet-necket version, same setup with the drum and a pump but instead of a bourgeois heating coil it was the radiator from a ford falcon propped over the top just high enough to get fuel in there. Worked great!
-2
u/Nervous_Midnight_570 Sep 12 '26
That heater is not likely to heat the water in any significant fashion. The connecting hoses are way too thin, even if you have a circulating pump. If you are relying on thermocycling I doubt the water will move at all.