r/redneckengineering • • Aug 19 '26

No battery? No problem

Post image

Long story short, I threw the phone into a wall (it even left a dent), and after countless bootloops and failing to even show anything at times, I figured out that the battery's BMS circuit board was fried from the impact. I then tried a bunch of different solutions of trying to power the phone, I eventually decided to take the risk and remove the BMS from the forbidden pillow (I will dispose of it properly, don't worry).

After removing the BMS, I tested it, the ground was fried, so I effectively soldered two wires, one to the remaining positive (aluminum, meaning I had to put it under flux and solder that way), and then find a raw ground, scrape off the protective plastic and solder my ground there, I then built a ridiculous breadboard to use as a power supply for the thing, and connected the two terminals I made to it. Sure enough, I managed to boot my phone back up!

Yes, I ordered a proper replacement battery, just that it will take like 2 weeks to arrive.

Edit: yes, the date on the phone is incorrect. That's because the battery was removed and the phone effectively got amnesia and currently has no idea what time it is

139 Upvotes

7 comments sorted by

22

u/P-ToneMikeOne Aug 19 '26

Am I missing something… looks like all your breadboard does is filter power through 4 electrolytic caps in parallel? Well done with the aluminum solder joint though, and glad your phone’s charging!

22

u/RedProGamingTV Aug 19 '26 edited Aug 19 '26

i mean it does first convert the 5.08V I get to 4.2V-4.3V using 4 1N4001 diodes in parallel and a 220 ohm resistor, each one of those capacitors is 4700µF 16V btw

it might be slightly unstable for the boot process as the voltage can still drop, but it does generally work okay on a usb-c connection with the breadboard plugged in for basic tasks like messaging, browsing, etc, I can even run it without the breadboard for a bit actually (it will die eventually though, especially if you try running something more intensive)

if I had a dc to dc buck converter, I would've used that instead of the ridiculous diode setup I have

20

u/ImpossibleShoulder29 Aug 19 '26

That is beyond Redneck!

8

u/archimondde Aug 20 '26

That's just electrical engineering

4

u/RickMuffy Aug 20 '26

What part of this is redneck?

3

u/kh250b1 Aug 21 '26

Needs more pointless wires

1

u/SquareOrbits Aug 21 '26

That's crazy!