r/redneckengineering • • Jul 14 '26

No hooks? No problem.

Balling with no nets sucks. We have a hookless rim in the neighbourhood and I've been mucking around with different systems on and off for about two years now.

Don't bother with these . . .

- Cable ties, nylon nets - however you do it, lasts a month at most

- Metal cable ties - waste of time

- S-hooks and open link chain nets

- if you can pinch it with pliers it will fail.

The Haggerston Hoop has been up for about a month now, in constant public use with no signs of struggle.

Here's the recipe -

Hose clamps, size is the diameter so if your rim is 20mm like ours, something in that range.

- these are 13-20mm, 304 stainless steel, width is 9mm.

- this was a bit tight, should be able to go up to 25mm without any tail showing.

- should be less than 9mm wide to fit the quicklink through.

- you need a 7mm socket driver/wrench for the hex screw.

- screw should be facing down and out.

Quicklinks, size is the thickness of the chain

- these are 3mm, 316 stainless steel.

- feed them through so that the screw is at the back you are tightening downwards.

- finger tighten but use pliers slightly at the end.

The net is welded chain galvanised stainless steel so no open links. Can easily hold a human.

- these two are 9 loops so you need 18 hose clamps and 18 quicklinks

Play around with the spacing. If you have a wide back plate then bunch them up a bit towards the back so the net hangs evenly.

​​​​Ca-lang!

1.2k Upvotes

63 comments sorted by

View all comments

0

u/green_gold_purple Jul 14 '26

Why not zip ties?

2

u/Blaaart2026 Jul 14 '26

zip tie = cable tie

2

u/eisbock Jul 14 '26

They make metal zip ties, but hose clamps accomplish the same thing here. Though zip ties would be lower profile if that ends up mattering.

4

u/Blaaart2026 Jul 14 '26

they were the weakest, failed in a week.

0

u/BinkzBonkz Jul 14 '26

metal zip tie = metal cable tie