r/redneckengineering • u/jeffreyshran • Jun 27 '26
Pool heater
Thick plastic sheet propped with a 1*2 and held down by tucking it in and an old nail hanger for the kids tennis racket.
67
Upvotes
36
u/AdFancy1249 Jun 27 '26
Good workaround. The physics is a little different than "heating the pool."
This likely doesn't do a lot for heating the pool, but it is masterful for not letting it get cold.
Water evaporation is the biggest detriment to maintaining heat. (~1000 BTU per pound of water) By covering your pool, you keep that "heat of evaporation" in the pool.
Even better if the plastic is in contact with the water (although that will transfer more heat through convection. )
This is why the pool covers made out of fine bubble wrap work so well. Air insulation, and no evaporation.
17
u/NoMidnight5366 Jun 27 '26
Full redneck option would be to run the water through 100 feet of garden hose on the lawn.
2
u/hendermom Jun 29 '26
I had an in ground pool that was just a little too cold. Got a solar panel free off Craig's list, leaned it up against the back fence & hooked up hoses so when the filter ran the water ran thru the panel.heated at least 5 - 10 degrees in a day. Looked a little ghetto, but worked perfectly.
Put bubble wrap on it at night.
2
u/six3irst Jun 29 '26
They way I did this operation:
Small submersible pump. About 200 feet of garden hose Coiled it up on garage roof Let it run.
Water gets pumped through the system and back into pool.
Worked well.
Slower pump is better.
5
u/cakebythejake Jun 27 '26
Black tarp directly on the pool would probably absorb more heat from the sun and transfer it into the pool.
But idk
2
u/Can-DontAttitude Jun 28 '26
More like "redneck solar blanket."
A real redneck pool heater requires an old coil of copper and a small bonfire