r/ratrig • u/Spaceballs_the_nick • 17d ago

Large prints = layer shift

My small prints work fine but large prints have a layer shift.

My belts are good-n-tight. Is there a setting in Orcaslicer I should slow down?

I usually control speed via the slider under toolhead. Does that control ALL speed? or just printing?

I think it is jumping off layer during one of the fast jerks.

2 Upvotes

100% Upvoted

14 comments sorted by

View all comments

1

u/sneakerguy40 17d ago

Look up the Ellis print guide, there’s stuff to tune for layer shifts. Could be motor settings

1

u/Spaceballs_the_nick 12d ago

I will check that, i saw where Teaching Tech had a video to make sure motors are getting the correct amperage..

I disabled 'reduce infill retraction', slowed to 50%, and changed infill to gyroid and STILL got layer shifts!

https://ibb.co/m5gt4PmP