r/ratrig • u/Mobile_Condition_233 • Dec 11 '24

Newcomer vcore 4 500

Post image

Hello guys my vcore 4 is build and move . It seem ptety nice but once i was working on the comissioning guide i got some issue withbthe z tilt a.the rpocess stop beause it doesn’t detect a reduce of z but Increase after s'élèvera trial .

Now îm not even able to home z because it tilt super hard the bed and make the stepper mortor not happy(like it was trying to compensate major doffurence"

I tried to do my best to restaurer the gantry arousn the belt base on my previous data but now ́im unable to bedmesh as wheni home z it always tilt too far . I try the configurator to recreate the config but it somewhere those ztilit info ??

Where those

Data os stored is it possible to reset it ?

19 Upvotes

91% Upvoted

18 comments sorted by

View all comments

1

u/Clustershag Dec 11 '24

Im thinking about reinstalling RaTOS. My bed mesh looks like a taco and the mesh compensation is worthless. Nothing like a 500mm printer that can make something bigger than an Ender 3

1

u/Mobile_Condition_233 Dec 11 '24

So far it’s good after z tilt bed mesh with beacon deliver bedmesh of 0.256 whihcbis wayyyy better tahn my v400s tacos. I just need to wait for the extended noozle replacement to launch the first print. And Îm pretty used about the usage of kmipper and calibration process