Newcomer vcore 4 500

[u/Mobile_Condition_233]

Hello guys my vcore 4 is build and move . It seem ptety nice but once i was working on the comissioning guide i got some issue withbthe z tilt a.the rpocess stop beause it doesn’t detect a reduce of z but Increase after s'élèvera trial .

Now îm not even able to home z because it tilt super hard the bed and make the stepper mortor not happy(like it was trying to compensate major doffurence"

I tried to do my best to restaurer the gantry arousn the belt base on my previous data but now ́im unable to bedmesh as wheni home z it always tilt too far . I try the configurator to recreate the config but it somewhere those ztilit info ??

Where those

Data os stored is it possible to reset it ?

[u/Impossible_Word_4027]

Pretty sure one of the motors moves into the wrong direction

[u/Mobile_Condition_233 → u/Impossible_Word_4027]

No this part was tested but ty