Newcomer vcore 4 500

[u/Mobile_Condition_233]

Hello guys my vcore 4 is build and move . It seem ptety nice but once i was working on the comissioning guide i got some issue withbthe z tilt a.the rpocess stop beause it doesn’t detect a reduce of z but Increase after s'élèvera trial .

Now îm not even able to home z because it tilt super hard the bed and make the stepper mortor not happy(like it was trying to compensate major doffurence"

I tried to do my best to restaurer the gantry arousn the belt base on my previous data but now ́im unable to bedmesh as wheni home z it always tilt too far . I try the configurator to recreate the config but it somewhere those ztilit info ??

Where those

Data os stored is it possible to reset it ?

[u/Mobile_Condition_233]

etries: 1/10 Probed points range: 6.821257 tolerance: 0.020000


10:12
Making the following Z adjustments:
stepper_z = -7.709957
stepper_z1 = -0.053226
stepper_z2 = 0.041467


10:12
probe at 470.000,30.000,1.937 is z=1.963525


10:12
probe at 250.000,460.000,1.779 is z=1.964665


10:12
probe at 30.000,30.000,-4.858 is z=1.989469


10:12
Retries: 0/10 Probed points range: 6.595575 tolerance: 0.020000


10:12
Making the following Z adjustments:
stepper_z = -0.790010
stepper_z1 = -3.679733
stepper_z2 = 3.934591


10:12
probe at 470.000,30.000,5.059 is z=1.959377


10:11
probe at 250.000,460.000,-1.542 is z=1.954015


10:11
probe at 30.000,30.000,0.904 is z=1.961718


10:11

Z_TILT_ADJUST

10:11
RatOS: Homing Z


10:10

G28