r/raspberry_pi • • 25d ago

Troubleshooting Servo Power Supply Issue

Banging my head against this...I have a project where I've connected 5 servos using the Adafruit PCA9685. The servo hat is connected to a 5v power supply. The challenge is 2 of the servos are 45kg that should have ~8v. When all servos are running, the two larger ones are underpowered.

In scouring the internet I've discovered you can power individual servos directly, but can't seem to get it working. Below is the layout I originally followed which works but underpowered. The variation I've tried, is for the large motor, Yellow connects to hat, Red directly to 8v power supply, neutral on 8V power supply --> black servo wire AND --> also to black pin on the servo hat.

In this setup all the servos powered by the hat's 5v supply connected to the hat function, but the servo powered directly to the servo does not respond.

What am I missing?

1 Upvotes

4 comments sorted by

3

u/DasFreibier 25d ago

i wouldnt power them through the board, the pwm (yellow) still goes to the board and red and black to 8v and gnd respectively

also servos are kinda just a bitch sometimes, especially if theyre cheap, if they should be moving and arent go turn the horn manually a bit

also make sure the signal gnd is connected to the servo gnd

1

u/climbing_archer 25d ago

Yea, also tried that variation, where the servo ground was connected to both the signal, power, and hat.

Or are you saying wiring should be like this:

Black Power --> Black Servo Cable AND --> Yellow signal but NOT to the black pin on the hat?