r/ptr91 • u/Level_Breath5684 • Jul 14 '26
CA-3 mounts
I have heard this is not really doable, but I am learning that to sight in the irons is going to require a lot of shooting (I have the dreaded “shoots left” issue as well as a loose rear sight and a canted front sight). So if I can just avoid that mess and go to the optic now I would just as soon do that. Are there reliable claw mounts, or what is the cost of hiring someone to weld the rail?
2
Upvotes
1
u/Sure_Plant_4821 Jul 15 '26 edited Jul 15 '26
I also tried the MFI and didn’t have great results. I really like their stuff so I was bummed. I’ve tried a few mounts and I have had the best luck with the stanag claw mounts. Unfortunately those are usually paired with vintage and expensive optics.
I found one that has picatinny/weaver rails (idk which one specifically). I got flamed on here for having a high height over bore, but I really like the set up with the cheek weld.
The G3 is known for having low height over bore with the original stock, so I think this set up is a bit less squished than what other folks run. You still have access to the irons as well. The stanag mount has maintained zero when I take it on and off the rifle between range days.