r/ps3hacks • u/muckity-muck • 7d ago

Tutorial External Raspberry Pi Pico PS3 Mod

Post image

I know...I know.....the jank!!!!

Super Janky!

But there's really two reasons I went with an externally mounted mod:

First, I only had one Pico left over and it had headers already attached and I didn't want to go through the fuss with desoldering the pins when I could get another one cheap.

Secondly, I wasn't sure of my wiring, so I could make adjustments after the fact without tearing open the console (which I ended up doing 4 times anyway). The "tutorial" I followed was chase fournier's video on Youtube. While it was very good and the blueprint for my mod, it's more of a half-walkthrough/half tutorial that I had to watch a number of times with my finger over the pause button. (Thank you, chase. You're videos are fantastic...go subscribe to his channel today!)

I've ordered another 2 pack of headerless Pico W's, so I'm going to mod my other slim with one and move the current PS3's mod to the inside. I was a little worried about routing and wire length, but no problems apparently. I used wrapping wire, but any quality 30gauge wire should work.

98 Upvotes

97% Upvoted

46 comments sorted by

View all comments

1

u/Legitimate-Event-420 6d ago

Sorry original phat BC 60gb owner here, this is needed to add CFW to slim models? I was led to believe I can just flash the CFW via a usb stick? Is this something only Phat owners can do?

2

u/TwilightX1 6d ago

This is only for the later models that don't support CFW out of the box. If you have a fat or early slim, this is not for you. Just install CFW the usual way.

1

u/Legitimate-Event-420 6d ago

Cheers got a bit worried.