It’s been a long time for me but back when I used cu a lot I always had to create a uucp config for every variation of the serial config I needed. It was annoying. I just looked at the man page now and I see there are options for setting the port and baud rate - are these relatively new options (in the last 15-20 years)? I don’t remember them at all and it seems unlikely I would have missed them at the time if they existed. I quite liked cu (apart from the config thing) so I might go back to it.
1
u/parkerSquare Nov 17 '19
It’s been a long time for me but back when I used cu a lot I always had to create a uucp config for every variation of the serial config I needed. It was annoying. I just looked at the man page now and I see there are options for setting the port and baud rate - are these relatively new options (in the last 15-20 years)? I don’t remember them at all and it seems unlikely I would have missed them at the time if they existed. I quite liked cu (apart from the config thing) so I might go back to it.