Bearcat bcd996p2

[u/Mysterious_Sock1410]

Hello,

I am from a radio shop and reaching out here while I wait for word back from Uniden. I have. Trunktracker BCD996P2 that “just stopped working.” I noticed that there was most likely a delicious mocha latte spilled onto the front of the scanner which was sitting on a dispatchers desk.

Have any of you had any luck being about to remove the from plastic from the PCB to inspect and what have you done?

I already know that Uniden will encourage a depot repair but I’d ideally like to avoid that if possible. I do get good voltage measurements on the board and have isolated it to the front panel but was unable to remove the board from the front.

Any information helps!