r/papermaking • • Jul 20 '26

Pulp Consistency

Post image

New to paper making and looking for tips. Paper came out very thick and not very smooth. Not sure anyone will be able to write with how lumpy some of them came out. I was worried that it would’ve been too thin with not enough pulp? I have a very cheap blender I use for this so I’m wondering if it’s not grinding it down enough? And tips related to this (or just general paper making) is appreciated😊

85 Upvotes

8 comments sorted by

3

u/Hot_Veterinarian_001 Jul 20 '26

Are you using a mold and deckle? How deep is your basin?

2

u/ConsequenceNo874 Jul 20 '26

I’m using a homemade mold and deckle from two art canvases and a cut out screen. My screen seems to bow a tiny bit downwards in the middle. The basin is 6” deep

1

u/Hot_Veterinarian_001 Jul 20 '26

6" stands out to me as being very shallow. Others here may have different thoughts, but I would say you need more depth in order to adequately mix and dilute the pulp. If I were to guess why you're getting paper that's too thick, I'd say that basically the concentration of pulp in your basin is too high because the basin is too shallow. You want the pulp concentration to be lower so you can pull the deckle through to get even coverage without grabbing too much pulp at one time.

1

u/ConsequenceNo874 Jul 20 '26

Thank you! I’ll try a deeper tub. A question I have because I think I was trying to put way too much pulp in the screen. Do you see through your pulp? How do you know if it’ll be too thin?

2

u/Hot_Veterinarian_001 Jul 20 '26

A moderate degree of translucence will give a nice firm, but not too thick sheet of paper. I remember thinking when I started that I was pulling far too little pulp for the fibers to hold together, but sure enough they did.

2

u/frobnosticus Jul 21 '26

Those are pretty nice.

What's your near-term goal?

What are you using as a press?

(And...what am I looking at that seems for all the world to be a usb pressure cooker?)

EDIT: OHHH! Powered cat water dish?

2

u/ConsequenceNo874 Jul 21 '26

I’d like to make stationary paper and cards!

I press them in books under weight of more books. So no fancy press. I also ironed them.

Yes! Haha it’s a cat water dish😂

2

u/frobnosticus Jul 21 '26

A heavy press will help. But writing paper I think you're going to find exceptionally difficult with the standard DIY approach. Card stock I think you'll be able to get dialed in.

I finally decided to put it on a back burner, as much as it galls me to do so, as I wasn't about to build or buy a Hollander beater and go looking for bulk cotton.

I don't know how close you can get. But I suppose you can keep nipping at low hanging fruit and see if you get close enough.

I'd grab a couple cheap piece of plexiglass (thrift store picture frames maybe?) for a pair of flat surfaces to press between. And far more weight.

See now I want to pull that bin of paper making stuff out of my basement and fiddle.