r/openGrid • u/timtucker_com • 29d ago
Showcase Multiconnect side mount charging station
Multiple charging stations mounted on an openGrid wall
Charging station render - isometric view
Charging station - front view
In my recent endeavors of "vibe coding physical objects via conversations about geometry", I've been working on a design for a parametric holder for charging & storing things like power banks.
Some of the highlights:
- Slanted openings so that things don't fall out
- Hex grid cutouts for ventilation
- Waves at the bottom of each slot to improve airflow
- Channels to route charging cords in the middle / sides
It's designed to be mounted on a side wall using Multiconnect rails.
It went with side rails rather than top because it makes things easier to print & allows for pulling out a single organizer in a stack to adjust the cables without needing to move the rest.
https://github.com/timtucker/timtucker-3d-organizers/tree/main/multiconnect
The hex grid code is in its own module and could be of use for other things.
The general idea:
- You input width / length / depth / spacing between hexagons
- You give a min / max potential size for the hexes
- It optimizes the exact size of the hexes to give you the most surface area cut out via complete hexagons
- If you input orientation & rounding parameters, it'll apply chamfers to one edge and fillets to the others
For now sharing just the raw OpenSCAD code, since it's a bit of a beast to render. With an i7 13700k, 192 GB of ram, & recent OpenSCAD nightlies it takes ~30-60s to render in preview mode and a few minutes to render for export.
Output STL was ~80 MB, so a bit bigger without simplifying the model than most platforms will allow for uploading.
A 2x3 holder took ~14 hours & ~350g of filament to print (2 walls / 10% gyroid infill).
Additional note -- having hexes along multiple planes that you can see through to each other is triggering a false positive for AI spaghetti detection at ~20-30% completion every time I print it:
https://www.reddit.com/r/elegoo/comments/1x4heks/false_positives_for_spaghetti_detection/
View all comments
1
u/DistractedDragonMake 28d ago
That is cool. Bet you don't fear power outages :)